[Feb 19, 2022] Free Cisco 300-510 Exam Questions & Answer
Verified 300-510 dumps Q&As Latest 300-510 Download
Who should take the Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) Exam
People who wish to explore the power of the dynamic culture of the Cisco Learning Network to jump-start their certification and lifelong learning goals should take this exam. Those who want to get useful tools for IT training for all Cisco certifications should also get this certification. People with prior knowledge of integrating VPN services, including Layer 2, Layer 3, and IPv6, from the service provider are highly recommended to take this exam and get themselves certified from Cisco.
List of the target audience for this exam:
- Channel partners
- Network designers
- Network managers
- Network architects
- Network Operations Center (NOC) personnel
- Network administrators
- Network supervisors
NEW QUESTION 50
Which cost is the default when redistributing routes from BGP to OSPF?
- A. 0
- B. automatic
- C. infinite
- D. 1
Answer: A
Explanation:
Explanation/Reference: http://www.ciscopress.com/articles/article.asp?p=27573
NEW QUESTION 51
Refer to the exhibit.
A network engineer applied configuration on R5 to summarize all OSPF routes, but R4 is still receiving specific routes from R5. The engineer has confirmed that both R5 and R4 routers are configured with correct summarization configuration but R5 Is not sending the summary routes What action must the engineer take to fix the problem?
- A. Clear link-state database on both R4 and R5 routers for summarization to work
- B. Move R4 and R5 in separate areas as now they maintain the same link-state database
- C. Remove summarization configuration on R5 and configure it on R4
- D. Configure a sham link between R4 and R5 to support summarization within Area 2
Answer: B
NEW QUESTION 52
Which two conditions must be met before separate ISPs can provide interdomain multicast routing? (Choose two.)
- A. Each ISP must configure its network to use PIM-DM.
- B. Each ISP must configure MSDP to connect its individual multicast administrative domain to the domains at other ISPs.
- C. Each ISP must replace its RP assignment with a global RP.
- D. Each ISP must dedicate a single router to handle multicast traffic between providers.
- E. Each ISP must support intradomain multicast routing.
Answer: B,E
NEW QUESTION 53 
Refer to the exhibit. A network engineer implemented this segment routing configuration. Which statement about the output is true?
- A. This range conflicts with the segment routing local block range.
- B. The default segment routing global block range is being used on this device.
- C. The device must be reloaded for these ranges to be allocated and used.
- D. A nondefault segment routing global block range is being used on this device.
Answer: D
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/routers/asr920/configuration/guide/segment-routing/ segment-routing-book/seg-routing-global-block.html
NEW QUESTION 54
Compare different features between OSPFv2 and OSPFv3. Drag and drop the descriptions of OSPF from the left onto the correct OSPF versions on the right.
Answer:
Explanation:
NEW QUESTION 55
Refer to the exhibit.
A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology. Which configuration allows the injection in a way that XR3 and XR1 have a valid and working route for 10.16.16.0/24?
- A. Option C
- B. Option B
- C. Option D
- D. Option A
Answer: A
NEW QUESTION 56
Refer to the exhibit.
While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1. How should the engineer solve the issue?
- A. Set the network type in S1/0 to point-to-point.
- B. Modify the router ID to be the interface IP on the serial.
- C. Set up a priority different than 0 in the interface.
- D. Modify the IP address or mask of the interface to a valid one.
Answer: D
NEW QUESTION 57
Refer to the exhibit.
Router 1 is connected to router 2 on interface TenGigE0/1. Which interface provides the alternate path to 172.16.200.9/32 when the link between router 1 and router 2 goes down?
- A. TenGigE0/1 interface provides the alternate path
- B. TenGigE0/2 interface provides the alternate path
- C. A primary path must be manually installed
- D. A backup path must be statically installed
Answer: B
NEW QUESTION 58
You have configured routing policies on a Cisco IOS XR device with routing policy language. Which two statements about the routing policies are true? (Choose two.)
- A. You can change an existing routing policy by editing individual statements.
- B. The routing policies affect BGP-related routes only.
- C. The routing policies are implemented in a sequential manner.
- D. If you make edits to an existing routing policy without pasting the full policy into the CLI, the previous policy is overwritten.
- E. The routing policies are implemented using route maps.
Answer: A,C
NEW QUESTION 59
Refer to the exhibit.
Which task must you perform on interface g1/0/0 to complete the SSM implementation?
- A. configure OSPFv3
- B. configure IGMPv3
- C. enable CDP
- D. disable IGMP
Answer: B
NEW QUESTION 60 
Refer to the exhibit. After you applied these configurations to routers R1 and R2, the two devices could not form a neighbor relationship. Which reason for the problem is the most likely?
- A. The two routers have different IS-types.
- B. The two routers have the same network ID.
- C. The two routers cannot authenticate with one another.
- D. The two routers have the same area ID.
Answer: B
NEW QUESTION 61
Refer to the exhibit.
CE1 is the gateway router into the provider network via PE1. A network operator must inject a default route into OSPF area 0. All devices inside area 0 must be able to reach PE1. Which configuration achieves this goal?
- A. Option C
- B. Option B
- C. Option D
- D. Option A
Answer: A
NEW QUESTION 62
For which reason can two BGP peers fail to establish a neighbor relationship?
- A. Their BGP timers are mismatched
- B. Their remote-as numbers are misconfigured
- C. Their BGP send-community strings are misconfigured
- D. They are both activated under an IPv4 address family
Answer: B
Explanation:
Explanation/Reference:
NEW QUESTION 63
Refer to the exhibit.
Which effect of this configuration is true?
- A. It sets the hold timer to 30 milliseconds and the keepalive timer to 240 milliseconds
- B. It sets the hold timer to 30 seconds and the keepalive timer to 240 seconds
- C. It sets the keepalive timer to 30 milliseconds and the hold timer to 240 milliseconds
- D. It sets the keepalive timer to 30 seconds and the hold timer to 240 seconds.
Answer: D
NEW QUESTION 64
What can be used to determine a path from the head-end to a tail-end router when implementing SR-TE with a head-end, with little information on the network topology?
- A. SNMP server
- B. path computation engine
- C. traffic controller
- D. tail-end router
Answer: B
NEW QUESTION 65
Refer to the exhibit
Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?
- A. R5
- B. R2
- C. R3
- D. R4
Answer: B
NEW QUESTION 66
Which two statements about route reflectors are true? (Choose two.)
- A. If a route reflector receives a route with a cluster-list attribute containing a different cluster ID, the route is discarded.
- B. Routes received from nonclient peers are reflected to route reflector cluster as well as OSPF peers.
- C. Routes received from a route reflector client is reflected to other clients and nonclient peers.
- D. If a router received an iBGP route with the originator-ID attribute set to its own router ID, the route is discarded.
- E. Routes received from nonclient peers are reflected to route reflector clients as well as nonclient peers.
Answer: C,D
Explanation:
Explanation/Reference: http://www.networkers-online.com/blog/2009/02/bgp-route-reflector-basics/
NEW QUESTION 67
Refer to the exhibit.
A network operator wants to expand the segment routing global block in upcoming maintenance. The operator must ensure that the changes to the segment routing global block have no adverse impacts on the prefix-sid associated with the loopback0 interface used within the OSPF domain.
Which command can the operator use to enforce R2 to have a strict prefix-sid assignment to loopback0?
- A. Option C
- B. Option B
- C. Option D
- D. Option A
Answer: A
NEW QUESTION 68
Refer to the exhibit.
A network operator is working to deploy a Unified BGP design and allow it to be available only in selected markets and services in the future. The label allocation is not functioning as desired. Which action will fix the issue?
- A. Remove the route policy and only configure "allocate-label".
- B. Reconfigure the route-policy ALL_LABELS to match all after the drop.
- C. Remove the allocate-labels command.
- D. Reconfigure the route-policy ALL_LABELS to pass.
Answer: D
NEW QUESTION 69
After an engineer configures BGP in R1, it starts receiving this message
*Jun 29 13:30:50.122: %BGP-5-ADJCHANGE: neighbor 192.168.10.1 Down User reset Jun 29 13:30:52.341: %BGP-3-NOTIFICATION: sent to neighbor 192.168.10.1 2/6 (unacceptable hold time) 0 bytes Which action makes the peering come back up again?
- A. Set up a minimum hold-down timer higher.
- B. Set up a hold-down timer higher.
- C. Make a soft reset to the peer.
- D. Set up a hello timer higher.
Answer: A
NEW QUESTION 70
......
Use Real Dumps - 100% Free 300-510 Exam Dumps: https://www.verifieddumps.com/300-510-valid-exam-braindumps.html
Updated 100% Cover Real 300-510 Exam Questions - 100% Pass Guarantee: https://drive.google.com/open?id=1nCUj01ozQyVNA97rrsOKbB6_M4PSOYql
