[Nov-2023] 350-501 PDF Dumps Are Helpful To produce Your Dreams Correct QA's
New 350-501 exam Free Sample Questions to Practice
NEW QUESTION # 94
Refer to the exhibit.
A network administrator implemented MPLS LDP changes on PE-A LSR device. The engineer must ensure there are no LDP peer are fully operational. Which LDP feature must the engineer apply to the existing configuration to eliminate the problem?
- A. Enable LDP session protection under the routing protocol.
- B. Configure MPLS LDP IGP synchronization on the network.
- C. Configure MPLS LDP NSR for all LDP sessions.
- D. Disable IP CEF on routers running LDP and enable LDP.
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/msp/configuration/xe-3s/mp-ha-xe-3s-book/mp-nsr-ldp-supp.pdf
NEW QUESTION # 95
Refer to the exhibit.
An engineer wants to determine which paths are best, second best, third best, and fourth best. Drag and drop the peer addresses on the left to the corresponding BGP best-path selection order on the right.
Best - 50.50.50.2
2nd Best - 40.40.40.2
3rd Best - 20.20.20.2
44th Best - 30.30.30.2
Answer:
Explanation:
NEW QUESTION # 96
Refer to the exhibit.
An engineer is updating this network to meet these conditions:
* Area 10 will receive inter-area routes and support mutual redistribution of external routes with the extranet.
* The ::/0 route is prohibited in Area 10.
* Area 11 will receive only the ::/0 route from the ABR.
* External route redistribution is not supported in Area 11.
* The ABR in Area 11 will advertise no interarea routes.
Which two configurations must be performed to meet the requirements? (Choose two.)
- A. Configure area 10 as stub on R9 and XR32.
- B. Configure area 10 as nssa on R9 and XR32.
- C. Configure area 11 as nssa default-information-originate on R7 and as nssa on XR31.
- D. Configure area 11 as stub no-summary on R7 and as stub on XR31.
- E. Configure area 11 as nssa no-summary on R7 and as nssa on XR31.
Answer: B,D
NEW QUESTION # 97
Refer to the exhibit.
While troubleshooting the network, a network operator with an employee id: 3812:12:993 is trying to ping XR1. Which result should the operator expect when trying to ping to an XR1 local address?
- A. All ICMP traffic is dropped.
- B. ICMP traffic works at a policed rate of 19 bytes per second every 100 ms
- C. ICMP traffic works at a policed rate of 19 packets every 100 ms.
- D. All ICMP traffic responds successfully.
Answer: D
NEW QUESTION # 98
Which statement about the Cisco MPLS TE forwarding adjacency feature is true?
- A. It enables the tailend router to advertise routes to the headend router over the tunnel
- B. It enables the Cisco MPLS TE tunnel to be advertised into the running IGP.
- C. It enables the MPLS core to use EIGRP as the routing protocol
- D. It enables the headend and tailend routers to establish a bidirectional tunnel
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_te_path_setup/configuration/xe-16/mp-te- path-setup-xe-16-book/mpls-traffic-engineering-forwarding-adjacency.pdf
NEW QUESTION # 99
Refer to the exhibit:
R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1. these log messages are seen.
Which command can be configured on routers R1 and R2 on fO/O interfaces to form OSPF adjacency?
- A. ip ospf network broadcast
- B. ip ospf network non-broadcast
- C. ip ospf network point-to-point
- D. ip ospf network point-to- multipoint non-broadcast
Answer: C
NEW QUESTION # 100
Refer to the exhibit:
After implementing a new design for the network, a technician reviews the pictured CLI output as part of the MOP.
Which two statements describe what the technician can ascertain from the ImpNull output? (Choose two.)
- A. Label 0 is used for the prefix displayed and will be part of the MPLS label stack for packets destined for
192.168.10.10 - B. Label 3 is in use for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10
- C. Penultimate Hop Popping is in use for the prefix displayed
- D. Label 0 is used for the prefix displayed but will not be part of the MPLS label stack for packets destined for 192 168.10.10.
- E. Ultimate Hop Popping is in use for the prefix displayed.
Answer: A,B
NEW QUESTION # 101
Which configuration enables BGP FlowSpec client function and installation of policies on all local interfaces?
A)
B)
C)
D)
- A. Option A
- B. Option B
- C. Option D
- D. Option C
Answer: D
NEW QUESTION # 102
Refer to the exhibit. An engineer is configuring IS-IS on ISP network. Which IS-IS configuration must an engineer implement on router AGG1 so that it establishes connectivity to router AGG6 via the BB3 core router?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: B
NEW QUESTION # 103
Drag and drop the OSPF area types from the left onto the correct statements on the right
Answer:
Explanation:
NEW QUESTION # 104
Refer to the exhibit:
An engineer wants to authenticate the OSPF neighbor between PEA and PE-B using MD5.
Which command on PE-B successfully completes the configuration?
A)
B)
C)
D)
- A. Option A
- B. Option B
- C. Option D
- D. Option C
Answer: A
NEW QUESTION # 105
Refer to the exhibit.
What reestablishes the OSPF neighbor relationship between Router 1 and Router 2?
- A. OSPF process IDs match
- B. hello intervals match
- C. authentication is added to the configuration
- D. correct wildcard mask is used on Router 2
Answer: B
NEW QUESTION # 106
Refer to me exhibit. An engineer started lo configure a router for OSPF.
Which configuration must me engineer perform on me router without changing any interface configuration so that the router establishes an OSPF neighbor relationship with its peer?
- A. Option A
- B. Option B
- C. Option D
- D. Option C
Answer: A
NEW QUESTION # 107
How does model-driven telemetry use YANG?
- A. to subscribe to data that is streamed from a device
- B. to reset network devices that malfunction
- C. to set informs and traps on clients to report back to a centralized server
- D. to poll network devices on a 30-minute interval
Answer: A
Explanation:
Section: Automation and Assurance
NEW QUESTION # 108 
Refer to the exhibit. What does the REST API command do?
- A. It displays the information identified by Descriptions.xml.
- B. It executes the information specified in Descriptions.xml.
- C. It retrieves the information requested by Descriptions.xml.
- D. It removes the information identified by Descriptions.xml.
Answer: C
Explanation:
Section: Automation and Assurance
NEW QUESTION # 109
A company is expanding its existing office space to a new floor of the building, and the networking team is installing a new set of switches. The new switches are running IGMPv2, and the engineers configured them for VLAN10 only. The rest of the existing network includes numerous Layer 2 switches in multiple other VLANs, all running IGMPv3. Which additional task must the team perform when deploying the new switches so that traffic is switched correctly through the entire network?
- A. Configure all switches on the network to support IGMPv2 and IGMPv3 on VLAN10 only.
- B. Configure the new switches to use IGMPv3 on VLAN10 only.
- C. Configure the new switches to use IGMPv3 on all VLANs on the network.
- D. Configure all switches on the network to support IGMPv2 and IGMPv3 on all VLANs on the network.
Answer: B
NEW QUESTION # 110
......
Cisco 350-501 Exam Domains Explained
The Cisco 350-501 exam can be scheduled at Pearson VUE and has a total duration of 120 minutes. It confirms if a trainee can implement fundamental service provider network solutions and technologies by addressing the following topics:
- Architecture
Under this section, the candidates have to show their thorough understanding of service provider architectures and virtualization, the architectures of the Cisco network software, data plane security implementation and management, and QoS architecture. Skills in configuring and verifying control plane security are required as well.
- Networking
This domain emphasizes the implementation of OSPF and IS-IS as well as checks one's knowledge of the BGP path selection algorithm. The candidates also need to understand how to apply the route maps and routing policy language efficiently and resolve the issues related to routing protocols. Finally, the concepts of the high availability implementation and IPv6 transition are included in this section as well.
- Automation and Assurance
This domain starts by covering the programmable APIs and their role in Cisco network automation. Then, it focuses on the interpretation of an external script and configuration of Cisco devices using the REST API. What's more, this topic will also address the concepts of agent and agentless configuration tools, data analytics, gRPC, configuration and verification of the NetFlow/IPFIX, RESTCONF, and NETCONF, and SNMP (v2c/v3). Finally, the advantages of specific data modeling languages like YANG are involved as well as the significance of Network Services Orchestration (NSO) and model-driven telemetry, among the rest.
- Services
The topics under this module mainly assess the applicants' competence in setting up L3VPN and L2VPNalong with Carrier Ethernet. Also, one should be proficient in the implementation of QoS and multicast services and understand all the main features of the VPN services well.
- Segment Routing and MPLS
This module revolves around the implementation of MPLS, the concepts of traffic engineering, and segment routing. The applicants should demonstrate their skills in working with LDP session protection, Unified MPLS, LDP Neighbors, TI-LFa, IGP Control Plane, Segment Types, FRR, and RSVP Functionality, and among the rest.
Cover 350-501 Exam Questions Make Sure You 100% Pass: https://www.verifieddumps.com/350-501-valid-exam-braindumps.html
350-501 dumps Accurate Questions and Answers with Free: https://drive.google.com/open?id=1LORIONC0dTOpAUiEhA9rLXEUyCH8eA8y
